RF PCB design
Controlled-impedance layouts, stackup planning and RF front-end routing that keep signal loss, noise and coupling under control.
See detailsRF and antenna engineering, designed and verified.
Ampnode Technologies designs RF PCBs and antennas, then tests them, so your wireless product performs the way the datasheet says it should.
What we do
Four services that cover a wireless product from first schematic to measured results.
RF testing
Bench measurements of your RF hardware, with clear reports on power, spurious emissions, sensitivity and matching.
See detailsAntenna design
Simulated, tuned and matched antennas sized for your enclosure, from PCB trace and chip antennas to patch and custom designs.
See detailsAntenna testing
Return loss, gain, efficiency and radiation pattern measurements, so you know how the antenna behaves inside your product.
See detailsHow a project runs
A simple process with a checkpoint at every stage.
Requirements
We agree on bands, range, size, power and certification goals.
Design
Schematic review, layout or antenna simulation, with your feedback.
Prototype
Boards and antennas are built and brought up on the bench.
Test and tune
We measure, tune the match and deliver a report with results.
Why teams work with Ampnode
Design and measurement under one roof means problems are found and fixed faster.
Design and test together
The engineers who design your board or antenna also measure it, so there is no hand-off gap.
Measured, not assumed
Every design is checked against real measurements, not only simulation.
Clear reports
You receive plots, data and plain-language findings you can act on.
Have an RF or antenna problem?
Tell us about your product and we will reply with how we can help and what it would take.
Contact us